Tech Tip #8 - Reamer Guidelines

Kennametal can recommend a drill size that will leave an appropriate amount of material for the reamer to efficiently size the finished hole.

General guidelines for drill sizes are:

  • <1/4” = .010”
  • ¼” to ½” = .015”
  • ½” to 1-1/2” = .025”

A common misconception is to leave too little material for the reamer to remove. The reamer needs enough material to make its cut. Too little material will cause the reamer to rub or burnish and results in accelerated wear and poor surface finish.

Cutting speeds should be about two-thirds that of drilling SFM for similar material and feeds should be two to three times higher. 

내 솔루션 페이지에 을(를) 추가하려고 합니다.. 진행하시겠습니까?
Select the destination where you want to move 받는 사람.
신제품 Folder
    • Applied Filters:
    • Clear All

product-image
Please adjust the following properties from

ISO 카탈로그 번호

ANSI 카탈로그 번호

to find similar products.

The following files are available

Please select a file to download

Models

Product data

대시보드 정보를 보려면 로그인해야 합니다.
Session expired due to inactivity, please login again
장바구니에 추가하려는 제품()을 사용할 수 없습니다. 고객 서비스에 문의하십시오.
항목이 장바구니에 추가되었습니다.

. Please enter the desired qty for the material(s) you want to include in your promotion or Proceed Without Promotion and only your base materials will be added to the cart.

Minimum quantity should be

SAP Material Number ISO 카탈로그 번호 등급  

You are about to leave the Solution building process.

Are you sure you want to leave?

Standard

ALL

Material

Select a Value

Hardness

--

Hardness Scale

--

Permitted Groups :

Group

SubGroup

Hardness (HB)

Hardness (HRC)